News

1. Whether the four legs of the display rack are flat? This is clear when you lay it flat on the ground. Some display rack products only have three legs on the floor. See if the table is straight, you can't bend your back or collapse your waist. Pay attention to check the cabinet door, the slits of the drawer can not be too large, pay attention to horizontal and vertical, the door can not slide down.

2.the jointing of the veneer display racks is strict. Whether it is wood veneer, PVC, or paint paper, we must pay attention to whether the leather is flat, whether there is bulging, blistering, and loose joints. During the inspection, look at the light. If you don't, you can't see the problem. Fraxinus mandshurica veneer display racks are relatively easy to damage and generally only last two years. As far as wood veneers are concerned, veneers with cut edges are better than rotary cuts. The way to identify the two is to look at the pattern of the wood. The texture of the cut veneer wood is straight and dense. When you choose the display rack for rotary cutting, the appearance of the display rack can be directly found. This can be understood by introducing the following To, but the pros and cons of the display rack should not only pay attention to the appearance of the display rack but also pay attention to the role of the display rack in displaying products. A good display rack can increase the attractiveness of the goods. Let's first take a look at how to see the quality of the display rack. How to see the quality of the display rack? The veneer pattern is curvy and sparse.

The edge of the display shelf of the flower board must be filled with edge seals. Without the edge seals, it will absorb moisture, swell and be damaged. Generally, the corners and corners of veneer display racks are easy to warp. You can buckle the corners by hand when selecting. If you buckle up, it means there is a problem with the glue.

3. Whether the edge of the display frame is smooth and the edge sealing is uneven, indicating that the inner material is wet, and the edge sealing will fall off in a few days. Edge banding should also be rounded, not right-angled. Edges sealed with wooden strips are prone to moisture or cracking. For the display racks covered with plywood, nails are used at the batten. Pay attention to whether the nail holes are smooth and whether the colors of the nail holes are consistent with other places. Usually, the nail holes are swollen with putty. If the bulge does not work, the putty will fall out from the inside.

4. look at the quality of the paint, look at the light on the surface of the paint display shelf, whether there are "prickly heat", small flowers like dust. Look at the side of the display rack whether there will be "tears", that is, whether there are teardrops in the paint, it is a bit like waterdrops.

The above is an introduction to "how to look at the quality of the display rack". The production of the display rack requires a lot of effort. At the beginning of the production, it is necessary to carry out innovative design. This is the responsibility of the display rack designer, and the display rack manufacturer It is a key part of turning the display stand from the design drawing into reality.